Cleaning the filter:
The filter is located on the side panel of the appliance.
Unclip to remove, then remove dust and dirt using a
vacuum cleaner. The filter should be cleaned every
two weeks to maintain optimum performance. Using a
dry 1" (25mm) paint-brush, remove any dust from the
grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or
an authorised service centre. If the mains plug needs to be replaced,
proceed as follows:
•
Connect the brown wire to the
terminal labelled "L".
•
Connect the blue wire to the terminal
labelled "N".
•
Connect the green/yellow wire to the
terminal labelled with the earth symbol
or "E".
•
Make sure that the cord-grip is
positioned correctly (over the outer
sheath of the cable) and it fully
tightened.
FAULT-FINDING
If the appliance is not operating, proceed as follows:
Check that the mains plug is firmly in the socket, and that the socket is
switched ON.
When the unit if switched on there will be a delay of about 1 minute
before it starts to operate.
•
Unit stops running:
Mains supply is disconnected or has failed
Target temperature has been reached.
Timer has been set.
Water tank is full (WATERFULL indicator will illuminate)
•
DF is shown on the display
The appliance is defrosting. This is normal.
•
In cooling mode, no cool air is produced:
Room temperature is lower than set temperature
Page 8