Cooling mode: cools if the room temperature is above the selected
temperature.Then use the
s
and
t
buttons to select the desired
room temperature. When the temperature reaches the desired
temperature, the compressor will stop, and the fan will continue to run.
Dehumidifying mode: removes humidity, but does not affect room
temperature. The fan operates at its lowest speed. For best results,
do not use the exhaust tube, but fit a permanent drainage pipe to the
drain outlet as shown on page 7.
Fan mode: circulates the air, but does not affect room
temperature or humidity. The exhaust tube is not requires in fan
mode.
"SPEED" Button: Set the fan speed using the fan speed control.
In all modes except dehumidifying mode. The fan speed can be low,
medium or high. The fan speed is indicated by the speed of the segments
on the windmill symbol on the LED display.
s
and
t
buttons:
Use the
s
and
t
buttons to select the desired room temperature. The
temperature can be set to any temperature from 18 °C to 30 °C. Selecting
a higher temperature whilst cooling will reduce power consumption.
Pressing both
s
and
t
buttons together changes the display between
Celsius and Fahrenheit.
SWING button: Press the "SWING" button to turn the oscillation
of the louvres on or off.
ECONOMY MODE. Press the
button to select economy mode. In
economy mode the fan speed is reduced, the cooling temperature is fixed
at 27°C.
WATER INJECTION.
If the water injection indicator
illuminates then the cooling efficiency
can be enhanced by adding water to the water injection tank. The filler is
located at the right hand side, next to the handle. (see drawing on page
2). Do not add water in fan or dehumidifying modes.
Page 5