3
INSTALLATION
It is very important that the tubular heater is mounted horizontally to a wall at low-
level. Do not mount below a socket outlet. Any shelving above the heater must be
at a distance of no less than 200mm. Air should be allowed to circulate freely
around the heater in order to prevent overheating.
THE TUBULAR HEATER MUST NOT BE COVERED.
The fixing brackets should be mounted accordingly to the heater length at a
distance to adequately support the Heater.
Screw the two bottom halves of the brackets to the wall. Place the Tubular Heater
on the brackets. Fasten the top brackets over the tube. DO NOT SWITCH ON
THE HEATER UNTIL AFTER IT HAS BEEN SECURED.
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested). We recommend that it is PAT tested regularly
when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings).
ELECTRICAL
The electrical installation of this Tubular Heater must be carried out by a competent
electrician and be in accordance with the current I.E.E. Regulations for Electrical
Equipment in Buildings. The Tubular Heater is suitable for operation on a 50Hz AC
supply voltage as shown on the identity label. Before connecting the heater check
that the supply voltage is the same as stated on the identity label.
DO NOT
DIRECTLY EXPOSE TO WATER
THIS DEVICE IS NON-USER SERVICEABLE
Should difficulty be experienced with this heater, consult a qualified electrician.
MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.
