Page 13
For technical questions, please call 1-888-866-5797.
ITEM 63022
SAFETY
SETU
p
Op
ERA
TION
M
AINTENANCE
Daily Maintenance
1.
Before each use:
Inspect the general condition
of the Auger. Check for misalignment or binding
of moving parts, cracked or broken parts, dull,
bent, or damaged Bit, and any other condition
that may affect the safe operation of the tool.
2. A Bit that is bent or packed with dirt and debris
can cause personal injury. Replace a damaged
Bit and keep the Bit clean at all times.
3. Check the Air Filter prior to each use for
excessive dirt and debris buildup, clean as needed.
4. After each use, clean the exterior of
the Engine with a clean cloth and mild
detergent. Do not use solvents. Remove
the Bit from the Engine and use a garden
hose to wash off any dirt. Do not introduce
liquids into the interior of the Engine.
Checking and Filling Fuel
WARNING!
TO pREVENT SERIOUS
INJURY FROM FIRE:
Fill the fuel tank in a well-ventilated area
away from ignition sources. If the engine is
hot from use, shut the engine off and wait
for it to cool before adding fuel. Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
3. Remove the Strainer and remove any dirt
and debris. Then replace the Strainer.
Note: Do not use gasoline containing more than
10% ethanol (E10). Do not use E85 ethanol. Add fuel
stabilizer to the gasoline or the Warranty is VOID.
Note: Do not use gasoline that has been stored in a
metal fuel container or a dirty fuel container. It can
cause particles to enter the carburetor, affecting
engine performance and/or causing damage.
IMpORTANT:
Your Warranty is VOID if the Engine’s
Fuel Tank is not filled with the proper mixture (25:1) of
unleaded gasoline and 2-cycle oil
before each use.
Before each use, check the fuel level. Do not run the
Engine with an improper unleaded gasoline/2-cycle oil
mixture. Running the Engine with an improper
mixture WILL permanently damage the Engine.
1 GALLON
UNLEADED
GASOLINE
5 FLUID OUNCES
2-CYCLE OIL
AppROVED
CONTAINER
Figure E: Fuel-Oil Mixture
4. To obtain the proper gasoline
and 2-cycle oil mixture, mix
5 fluid ounces of
2-cycle oil with 1 gallon of unleaded gasoline
into an approved container. Then gently agitate the
container to thoroughly mix the gasoline/2-cycle oil.
5. If needed, fill the Fuel Tank to about 1 inch
under the fill neck of the Fuel Tank with
the pre-mixed unleaded gasoline/2-cycle oil mixture.
6. Replace the Fuel Cap.
7. Wipe up any spilled fuel and allow excess
to evaporate before starting engine.
To prevent FIRE, do not start the engine
while the smell of fuel hangs in the air.
Air Filter Maintenance
1. Wipe off and remove the Air Cleaner Cover (79).
2. Remove the Head Cover Bolt (81),
the Air Filter Cover, and the plate holding
the Air Filter in place. Note the placement
of the plate so the bolt hole in the center
is in alignment for re-assembly.
3. Remove the Air Filter and check for
dirt. Clean as described below.
4.
Cleaning:
• Wash the filter in warm water and mild
detergent several times. Rinse. Squeeze out
excess water and allow it to dry completely.
Soak the filter in lightweight oil briefly,
then squeeze out the excess oil.
5. Wipe off the Air Cleaner Case (73).
6. Install the cleaned filter in reverse order of removal.
Secure the Air Cleaner Cover before use.
