Page 6
For technical questions, please call 1-888-866-5797.
ITEM 62323
SAFETY
SETU
p
Op
ERA
TION
M
AINTENANCE
Set Up
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY: Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required. The operator should contact local fire agencies for laws or
regulations relating to fire prevention requirements.
TO pREVENT SERIOUS INJURY FROM ACCIDENTAL STARTING: Turn the power Switch
of the equipment to its “OFF” position, wait for the engine to cool, and unplug the spark
plug wire(s) before assembling or making any adjustments to the equipment.
At high altitudes, the engine’s carburetor, governor (if so equipped), and any other parts that control
the fuel-air ratio will need to be adjusted by a qualified mechanic to allow efficient high-altitude
use and to prevent damage to the engine and any other devices used with this product.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagrams near the end of this manual.
Assembly
1. Slide a Wheel (17) and Flat Washer (19) onto
each end of the Axle Assembly (16) at the
lower rear of the unit. Refer to Figure A.
2. Insert a Cotter Pin (18) through each
end of the axle and bend the Cotter Pin over
to secure the Wheels in place.
3. Secure the Support Leg (46) to the Engine
using Bolts (45), Shock Absorbers (53), Large
Flat Washers (54), Flat Washers (28), Lock
Washers (26) and Nylon Lock Nuts (34).
4. Attach the Handle (7) to the Hopper (4) using
Bolts (6) and Nylon Lock Nuts (5). Refer to Figure B.
5. To attach the Discharge Bag (56), lift the
Discharge Port Cover (22) and attach the Bag
onto the discharge port using the rope tie.
Figure A
Figure B
17
18
19
28
26
34
45
46
54
53
16
6
5
7
4
22
56
