©2019 Precor Inc. | Prone Leg Curl RSL 606 | Assembly Guide
9
7
2 bumpers
1 add-on weight spacer, 2½-inch
1 add-on weight
1 add-on weight handle
Place one bumper onto the third guide rod, followed by the add-on spacer,
another bumper, the add-on weight, and the add-on weight handle.
8
1 M10 x 65 mm SHCS
2 washers, 11 mm
1 M10 nylon lock nut
Tools: Hex wrench, 8 mm
Socket wrench, 17 mm
Replace the cap to the top of the rod and secure top of rod to weight stack tow-
er frame.
9
1 washer, rubber
1 washer, silver 13.5 mm ID x 35 mm OD
Place the washers into the top of the cable connector in the add-on weight
handle.
10
Tool: Torque wrench
Attach the cable to the weight stack. Thread the bolt into the top plate assem-
bly until the cable meets
ALL
of the following requirements.
The top weight begins to separate from the second weight.
The selector pin can be easily inserted into each of the weight plates.
The add-on weight is engaged when the latch is in the down position.
At least six turns of the threads on the cable bolt extend into the add-
on weight selector stem.
The distance from the underside of the jam nut to the top of the washer should
be no more than
1.61 inch (41mm).
Tighten the locking bolt against the select stem to 50 ft-lb (81 N-m) of
torque.
27
44
42
34
40
12
11
7
9
7
34
40
42
11
12
27
44
7
9
41 mm
