©2019 Precor Inc. | Converging Shoulder Press RSL 515 | Assembly Guide
12
8
1 M10 x 65 mm SHCS
2 washers, 11 mm
1 M10 nylon lock nut
Tools: Hex wrench, 8 mm
Socket wrench, 17 mm
Replace the cap to the top of the rod and secure top of rod to weight stack
tower frame.
9
1 washer, rubber
1 washer, silver, 13.5 mm ID x 35 mm OD
Place the washers into the top of the cable connector in the add-on weight
handle.
10
Attach the cable to the weight stack. Thread the bolt into the top plate as-
sembly until the cable meets
ALL
of the following requirements.
The top weight begins to separate from the second weight.
The selector pin can be easily inserted into each of the weight
plates.
The add-on weight is engaged when the latch is in the down posi-
tion.
At least six turns of the threads on the cable bolt extend into the
add-on weight selector stem.
The distance from the underside of the jam nut to the top of the washer
should be no more than
1.61 inch (41mm).
Tighten the locking bolt against the select stem to 50 ft-lb (81 N-m) of
torque.
Check and further adjust cable connections at arms if needed.
11
1 weight labels
Remove back of labels. Align top holes on weights and labels and place pin
into hole. Remove pin and place into a lower hole on labels. Re-align labels
as necessary and then press firmly onto weights. Rub vigorously and thor-
oughly to adhere. Peel the extra label away and rub remaining labels again.
12
Lubricate the guide rods with a Teflon-based lubricant, such as Tri-Flow Su-
perior Lubricant. Remove any excess with a clean cloth or tissue.
46
52
54
32
37
39
37
54
46
52
39
41 mm
