The Heart Rate cable should be routed through the center of the armor, and then through the
upper left corner of the weldment. Route any excess Heart Rate cable into the rectangular cen-
ter section of the dash assembly.
Double check that all cables are fully and securely connected, and that cables are tied back
properly. Make sure any extra cabling is pulled down through the neck.
NOTE:
***For treadmill installations, make sure that the cables from the upright to the mounting neck
are routed along the front of the dash (using the attached flex ties), making sure the cables are
routed through the plastic guides inside the neck. ***
Tilt the control console back onto the mounting plate until the tab on the top edge of the armor
slides along the top edge of the mounting plate and the screw holes align properly.
Secure the console to the plate using the four flat head 5/8 inch long screws in the hardware
kit. Use the 5/8 inch long screws that come in the hardware kit, as they are a custom length for
this location. If you need additional screws (part number MCCN025-031) contact Precor. ½
inch screws are too short to provide the proper grounding required by the P80 and ¾ inch are
too long and can damage wires.
Tighten the screws fully using a
⁵
/
₃₂
-inch hex wrench.
Initial Configuration Steps:
After the P80 is physically installed, it must be configured for the specifics of the facility (TV set-
tings, network settings, etc.). Below are the steps that need to be performed for the con-
figuration, and in the order they need to be performed.
Steps to Perform on Each And Every P80:
These are settings that are unique to each specific P80, and therefore can’t be cloned (copied)
from console to console.
0 Verify that the software is at the current version, and update if necessary. (Section 6)
0 Connect the P80 to the facilities network. (Section 9)
0 Register the P80 with Preva Business Suite. (Section 9)
Steps That Can be Cloned (copied):
These are the settings that can be set-up on one P80, and then cloned to all the other P80s at
that facility.
0 Perform a channel scan. (Section 7)
0 Name all channels. (Section 7)
0 Save configuration and clone to all other P80s. (Section 8)
(Undefined variable: EFX800-16Base.ServiceManualTitle)
15
