page 13
WTLS
Similar to the interval course, this course provides a 28-minute course (4-minute rest and
4-minute work intervals) that maximizes your weight loss results. See
Using the Weight
Loss Program.
CUST1
Provides a timed-based course where you determine the resistance and ramp settings
while you work out. Once you complete the course, it is stored in the system’s memory
for future use.
CUST2
Provides a second custom course. See
Creating Custom Courses.
To use any one of the Program courses, follow the steps in
Working Out on the EFX and add the
following variation.
•
At the course prompt, enter a program name (choose one of the above).
Note: If you do not press ENTER to select a course, after 10 seconds the prompt “PRESS
ENTER TO BEGIN” appears. This prompt continues to scroll across the display every few
seconds until ENTER is pressed.
During your workout using the CT20, CT30, GLT20, and GLT30 courses, you can adjust the
resistance, but the ramp level is preset as shown in the course profile. You cannot adjust the ramp
setting.
Changing the Interval Course Profile
Interval training provides numerous benefits. Since interval training segments the workout into
smaller components, a 20- or 30-minute workout seems to pass more quickly. In addition, studies
have shown that it is a more efficient method for achieving aerobic benefits—you start seeing
improved cardiovascular fitness much sooner with less effort. Studies also show that people who
interval train are more likely to stick with their fitness program.
The interval course on the EFX lets you set the course intervals according to your training regimen.
It alternates between 2-minutes of “Rest” and 2-minutes of “Work.” During the Rest interval, you
can set a lower ramp and resistance and/or stride slowly; during the Work interval, you can quicken
your pace, set a higher resistance and/or higher ramp level. Once you set the first rest and work
interval, the software takes over, repeating the intervals throughout the course until you press the
PAUSE or Hold to Reset key.
At any point during the workout, you can change the settings of the current interval. For example, if
a “6” ramp setting and “5” resistance setting causes more effort than you prefer during a Work
interval, simply use the Ramp Control key and/or the Resistance key to change the settings.
The software remembers the new settings for the next Work interval.
If you have purchased the Precor Heart Rate Option and installed the heart rate receiver, you can
monitor your workout using the Smart Rate and Heart Rate displays.
Note: If you pause your workout during an Interval mode, you must reset the resistance of the
mode you were in when you paused your workout. For example, if you paused your workout during
the Rest interval, you must reset the resistance for that interval. In this example, you would not
need to reset the resistance for the Work interval since it is still stored in memory.
Below are some suggestions that may help you incorporate the Interval mode into your workout:
•
If you are starting an exercise program, the Interval mode option can help you increase your
workload gradually. For example, in the beginning, you may simply want to specify the same
resistance and ramp level for both Work and Rest intervals. Then, to increase your effort level,
change to a higher resistance and/or ramp setting for your Work interval.
•
If you are training with the goal of maintaining a constant pace when on level ground or grade,
specify the same resistance for both Work and Rest intervals. Then, gradually increase the
ramp during the Work interval while you maintain a constant pace.
