Precor Discovery Plate Loaded Line, Инструкция по сборке

Страница: 30 / 40

Incline Press Assembly Guide: Assembling the Equipment 12
Attaching the Back Pads
Note: The back pads are common to several models of exercise equipment, so
they have more screw holes than you can use in this procedure.
To attach the back pads:
1. Place the lower back pad against the center upright assembly so that the
screw holes on the assembly line up with the outermost screw holes on the
pad, as shown in the following figure.
Figure 8: Back pad attachment
Important: In the following step, be careful not to drop screws or washers into
the center upright. Inserting each screw into a socket wrench, then using the
wrench to position and tighten the screw, is recommended.
2. Place a 9mm flat washer over a
⁵₁₆
-inch x 1
¹₂
hex head screw, then insert
the screw through a screw hole in the center upright assembly and into the
corresponding hole in the pad. Partially tighten the screw. Repeat this step
to insert the other screw and washer.
3. Place the upper back pad against the center upright assembly, so that the
screw holes on the assembly and the pad line up.
Figure 9: Head pad attachment
4. Repeat step 2 to attach the upper back pad to the center upright assembly.
5. Position the back pads if necessary, then tighten all four screws
completely.
6. Press frame plugs into the screw hole openings on the center upright
assembly.