Precor c944, Руководство по обслуживанию, Страница: 6 / 46

C944 Treadmill
Page 6
THEN... OTHERWISE...
The treadmill lift switches are Press
RESET
to return to the
PRESS
calibrated correctly, press
ENTER ENTER FOR PROGRAMS
prompt,
to continue. then calibrate the lift systems
described in Procedure 4.1.
Note:
Software revision changes can only be made by replacing the currently installed PROM. The
revision of the software does not change by resetting the system. Some software updates may
require the user to perform a system reset.
Software numbers are invaluable for tracking and identifying problems and keeping abreast of
changes to the operation and features of the product.
8. The message
VERSION
scrolls across the display and will continue to do so while you hold
any key down. When the key is released you will see the software version number displayed
in the middle right seven-segment display. Press
ENTER
to exit this mode.
Note:
The following mode allows manual control of the motor speed while displaying the power bits. It
is useful in determining if the system is having difficulties running the motor and belt.
9. The message
POWER BITS
scrolls across the display once. Two numbers appear in the
right upper and right middle seven-segment displays. The upper number is the power bits
and the lower number is the requested speed in miles-per-hour (or kilometers-per-hour).
Press the
SPEED
▲
key to start the motor. The
SPEED
▲
,
SPEED
▼
,
STOP
and
ENTER
keys are active in this mode.
10. Press the
SPEED
keys while you watch the right display window. The power bits number
increments as the
SPEED
▲
key is pressed and decrements as the
SPEED
▼
key is
pressed.
11. Press either the
STOP
key or the
ENTER
key to stop the motor and exit this diagnostic.
Press the
SPEED
▼
key until zero MPH (or KPH) is attained if you wish to stop the motor but
not exit this diagnostic.
Note:
The keypad test is useful for troubleshooting stuck or non-operating keys on the keypad.