Precor 600 Series, Инструкция по сборке

Страница: 6 / 16

Dash attachment
IMPORTANT
Two people are required to assemble the dash.
To attach the dash:
1. With assistance, set the dash assembly on top of the upright supports.
NOTE
The dash slips down into the uprights. Pull it up slightly so that the screw
holes line up correctly.
2. Attach the dash assembly to each upright using three screws and three
washers . Partially tighten the screws.
Figure 5
3. Tighten all 12 screws to 25 ft-lb (33.90 Nm) of torque. Tighten the lower
upright screws in the order shown in Figure 6.
Figure 6
To complete the dash assembly:
1. Remove the two screws from the back of the dash cover. Remove the dash
cover and set it aside with the screws.
2. Route the data cable through the right tube of the dash assembly, up the back
frame, and out through the top hole.
NOTE
If you are attaching a PVS or networked console, route those cables
through the left side of the dash assembly at this time.
Figure 7
7