49
PWS APK-1 Hose Installation Diagram
13.
Slide a Nut/Cone/Ring over each end of the1/2” OD tube and insert the
hose into each elbow. Slide the nut to the threads and tighten using a 10”
adjustable wrench. Use caution. Do not over tighten.
14.
Screw the third elbow to the outlet of the pump. Tighten with a 10”
Adjustable wrench in a position that will work for routing the hose to the
faucet (usually toward the ceiling or floor). Be careful not to over tighten
as you could damage the pump.
Control Cable Connection Diagram
15.
After checking that all fittings are tight, turn the storage tank upright
and reinstall the charcoal filter canister and water distiller head on the
storage tank. See
Control Cable Connection Diagram
above.
Reconnect the control cable plug on the storage tank to the control
cable receptacle on the bottom of the water distiller head by turning
the plug until the splines lock and then turn the locking ring until finger
tight.
APK-1 INLET HOSE INSTALL DIAGRAM
OUTLET
INLET
DRAIN
PUMP ASSEMBLY
1/2FPTX1/2
ELBOW
ELBOW
1/2FPTX1/2
CONE
RING
NUT
1/2"OD TUBE
RING
NUT
CONE
1/2"OD TUBE MEASURE LENGTH
ADD 1-1/2" TO THE MEASURED LENGTH
MEASURED LENGTH
1-1/2" ADDED TO THE MEASURED LENGTH
WIRES
BOX
CONTROL
CABLE
Содержание PWS 12-20
Страница 2: ...2 This page left intentionally blank...
Страница 61: ...61 WIRING DIAGRAM PWS 12GPD AUTO...