5
Assembly
Remove the Hardware Sack or (hardware may be attached to other parts) and all loose parts from the carton
and verify that all the Parts and Fasteners shown on pages 3 and 4 are included.
Assembly Instructions
Note Right hand (R.H.) and Left hand (L.H.) are determined from the operator’s position while seated on the
Tractor.
1. (Pre-Assembled at Factory) Assemble the Angle Bracket to the Sweeper Housing using a M8x16 Hex Head
Bolt and a M8 Nylock Nut. Make sure the Angle Bracket is turned as shown and aligned straight with the
housing and tighten. See Figure 1.
2. Assemble the R. H. Hitch Tube to the Sweeper Housing using two M6x40 Bolt and two M6 Nylock Nuts
(hand tighten only at this time), insert Tube Plug into Hitch Tube. Then repeat the process on the L. H. Hitch
Tube. See Figure 2.
M6 x40 Bolt
M6 Nylock Nut
R.H. Hitch
Tube
Sweeper
Housing
Sweeper Housing
M8x16 Hex Head
Bolt
Angle Bracket
Nylock Nut M8
Figure 1 (Pre-Assembled At Factory)
Figure 2
Tube Plug
