4
WIRING
Before beginning, disconnect the negative (-) terminal of the
battery prior to working on the positive (+) terminal to prevent
a short to ground. This is important, unless you want to spend
the rest of your life with a nickname like
"Sparky," or "Smokey."
Reconnect the negative terminal only after all connections have
been made.
NOTE
Fuse must be
installed within
18" of battery
Drill a hole in the firewall
and use a rubber grommet
to keep wire from shorting.
Run the cables under the
carpet near the side of the
vehicle. Be careful not to
drill or screw into the wires
when you replace the trim.
Run signal cables (RCAs)
and remote turn-on lead
down the opposite side of
the vehicle of the power
wire to avoid radiated noise.
Firmly attach Ground
Wires to solid metal.
Avoid sharp edges that
could chafe through the
insulation.
Positive
Battery
Terminal
Factory Ground wire may
need to be replaced if it is
frayed or broken.
For systems over 300 watts,
add a ground cable from the
amp to the battery
Volume
Fader
Defeat
Sub
Low
Low-Mid
High-Mid
Treble
PAR-245
+
R
F
eject
VOLUME
BASS
TREBLE
RIGHT
LEFT
BALANCE
TRACK
REVERSE
FOWARD
1
2
3
4
8
7
6
5
PPI
MAR
KET
ING
DPT
Trk 1
Power distribution block.
Firmly attach Ground
Wires to solid metal.
+
+
+
BACK TO CONTENTS