PD6928 Loop-Powered Flow Rate/Totalizer
Instruction Manual
6
Disclaimer
The information contained in this document is
subject to change without notice. Precision Digital
Corporation makes no representations or
warranties with respect to the contents hereof;
and specifically disclaims any implied warranties
of merchantability or fitness for a particular
purpose.
•
Read complete instructions prior to installation
and operation of the meter.
•
This product is not recommended for life support
applications or applications where malfunctioning
could result in personal injury or property loss.
Anyone using this product for such applications
does so at his/her own risk. Precision Digital
Corporation shall not be held liable for damages
resulting from such improper use.
•
Failure to follow installation guidelines could
result in death or serious injury. Make sure only
qualified personnel perform the installation.
WARNING
Cancer and Reproductive Harm -
Limited Warranty
Precision Digital Corporation warrants this
product against defects in material or
workmanship for the specified period under
“Specifications” from the date of shipment from
the factory. Precision Digital’s liability under this
limited warranty shall not exceed the purchase
value, repair, or replacement of the defective unit.
See Warranty Information and Terms &
Conditions on
details.
Registered Trademarks
All trademarks mentioned in this document are
the property of their respective owners.
© 2022 Precision Digital Corporation.
All rights reserved.
Introduction
The PD6928 Vant loop-powered flow
rate/totalizer can be installed in a variety of harsh
operating environments to provide convenient and
informative display of any 4-20 mA signal. One of the
most convenient features of these instruments is their
dual-line display which is typically used to display the
flow rate on the 5-character alphanumeric top display
and flow total, flow grand total, or a tag on the
8-character alphanumeric bottom display. The top
display uses 12-segment, and the bottom display
uses 14-segment alphanumeric characters for clear
indication of tags, units, or alarm messages.
Further enhancing the display on these instruments is
a 20-segment bargraph.
These flow rate/totalizers can be installed virtually
anywhere because they get their power from the
4-20 mA loop and therefore require no separate
power source. And they only drop 1.5 V (4.7 V with
backlight), so they add very little burden to the loop.
Additional features that allow these instruments to be
installed virtually anywhere include a NEMA 4X, IP66
plastic enclosure, an operating temperature range of
-40 to 167°F (-40 to 75°C), conformally coated PCBs,
and a backlit LCD that can be read in bright sunlight
or dimly lit areas.
Free, PC-based, MeterView XL software that
connects to the meter via a micro USB cable is
available for programming and setup of the meters.
For more details, see the
. Four
CapTouch through-window buttons are available to
operate the instrument without removing the cover.
All models come equipped with two open collector
outputs and a digital input. There are also models
available with two solid-state relays and isolated 4-20
mA analog output options. The open collector outputs
are useful for alarm indication or pulse output. The
digital input can be used to remotely reset the total, to
start/stop a timer/stopwatch, and more. The relays
can be programmed for alarm indication, sample,
timer, batch control, or stopwatch.
Содержание PD6928
Страница 46: ...PD6928 Loop Powered Flow Rate Totalizer Instruction Manual 46 Relay Menu ...
Страница 79: ......
