PD6800-0L1 Explosion-Proof Loop-Powered Process Meter
Instruction Manual
20
Operation
Front Panel Buttons Operation
Button Symbol Description
Press to Enter or Exit
Programming Mode
Used to Reset Maximum and
Minimum Values
Press to Cycle Displaying
Maximum Value, Minimum
Value, and Input Current in mA
Press to Resume Run Mode in
Lower Display
Press to Acknowledge Alarm (if
Enabled)
Display Maximum, Minimum,
and Input Current
The maximum and minimum values and the meas-
ured input loop current may be displayed temporarily
on the lower display. To display these values, press
the
DISPLAY
button. The meter will display the word
MAXIMUM
on the lower display and the maximum value
reached (since the last maximum reset) on the top
display. Press the
DISPLAY
button again and the
meter will display the word
MINIMUM
on the lower
display and the minimum value reached on the top
display. Pressing the
RESET
button while either of
these values is displayed will reset that value to the
current display value.
Press the
DISPLAY
button a third time and the meter
will display
LOOP MA
on the lower display and the
measured input current in milliamps (mA) on the top
display. The current display will remain for 10 sec-
onds and then the lower display will return to normal
) on page
. Press the
DISPLAY
button a
fourth time to return to the normal operation. The me-
ter will display
RESUME
followed by the run mode lower
display.
Reset Meter to Factory Defaults
When the parameters have been changed in a way
that is difficult to determine what’s happening, it might
be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
Enter the
Advanced
Features Menu
.
Press and hold
Reset
button when
INFO
is shown.
For information on navigating to the
Information
menu, refer to
) on page
Press
Enter
when
RESET
DFALTS?
prompt is shown.
Note: If
Enter
is not pressed within three seconds, the
prompt will stop flashing return to showing
INFO
.
MENU
RESET
ENTER
DISPLAY
