Model No. BI-2000NT-CB20C1
Page 7of 8
JUNE 2011
TROUBLE SHOOTING
If your induction unit appears not to be working properly, it doesn't necessarily mean it's faulty. In all
cases, check the following points.
Malfunction Check…..
No indication light when power "on"
Cable/terminal block is loose
Broken circuit of fuse; or automatic switch in the power
supply
No
Power
supply
Heating indicator does not light, or is
flashing
Unsuitable cooking utensil
Appliance fails to heat up
No pan on the ceramic top
Utensil is not located at the centre of the ceramic plate
Utensil is smaller than 5cm
Appliance suddenly stops heating during
operation
Over-heating protection activated
Air entrance or outlet is blocked.
High ambient temperature
Error-Code,
ERROR CODE
BI-2000NT
Definition display-code
beeper-code
Temperature (coil-center) is open/short
" E "
1long-beep / 2-short-beep then off
Over-heat IGBT
" F “
1-long-beep / 7-short-beep then off
over-heat empty pot
" H “
19-short-beep & 1-long-beep, then off
over-voltage protection (too high or too
low)
“U “
1-long-beep & 4-short-beep, then off
If you fail to identify the problem contact the after-sales service without delay.
