1
Cirrus 1700 & 1500 Installation Guide
The Cirrus bath is supplied with the following:
Bath, Front Panel, Twin Waste Kit , 2 x Wall Fixing Brackets
Optional items
End Panel
Thermostatic valve 22mm – Must be installed in all cases
Bath Taps / Shower Mixer
IMPORTANT NOTES
The bath is supplied with 6 supporting feet and adjusted to nominal height of 510mm to keep the
door threshold/step at its lowest height for user comfort. Bath is filled only when user has entered
and shut door consequently taps must be thermostatically controlled.
Twin wastes are supplied to increase drainage rate and to ensure the bath can be drained if one
waste fails. The bath should be installed rigidly to ensure there is no movement or sagging of the
floor when bath is used.
Consideration should be given to lowering the wastes below the floor level to keep the step
threshold to a minimum. Use only shallow waste traps.
If fitting in an alcove, ensure the bath goes freely into position. Sideways pressure can distort the
doorway.
The bath is manufactured in glass fibre with a gel-coat surface. Handle with care. In particular the
bath edges are more brittle than in acrylic baths.
