8/28
●
ALIGNMENT/INSTALLATION/REPLACEMENT OF A LAMP
Lock the yoke before fitting/replacing the lamp. Just as Shown by Figure 1, after opening the cover at the rear of the projector by
loosening 4 fastfit screws, you can open the head.
To adjust the lamp as per Figure 2.
Take out the lamp as per the figure 3.
Before removing the lamp, unplug its power wires. After the lamp in, plug its power wires.
●
Don
’
t touch the internal surface of the reflector and the burner of the lamp with bare hands so as not to impair
the beam output. While lamp
’
s installation, do not damage the metal wire around the burner. While removing
the lamp, please hold the reflector with some force, but do not apply force to the ceramic stand, otherwise it will
be loose.
●
Please read "Instructions " enclosed with the lamp.
●
Do not operate the projector while adjusting the lamp.
.
●
GOBO REPLACEMENT
DANGER!
Before replacement of gobos, the projector must be off the power completely.
