9
submenus and each submenu has a specific function. For details, please see the “OPERATION MENU” with following
the 6
th
point..
1.
In the page of function setup, push any key of
◄, ►, ▲ and ▼
or icon for the function desired.
2.
At 2
nd
,3
rd
and 4
th
level menus, key
◄ means ESCAPE, key ► won’t function, key OK means ENTER. Push key OK to
save any changes o enter into submenus. Push key ▲or ▼ to change numbers(plus or minus) or tap any item required
for changes.
Push the left key or shortcut key X to go back to the upper level menu. If none pushed, the system will go back to initial display
automatically.
Shortcut keys: after the interface of FUNCTION MENU, the upper part is with menus for many functions. On the right, there are 4
shortcut keys, which are
←,→,lamp control or English/Chinese menus.
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3 DMX modes. There are short mode ,standard mode and extended mode. For example standard mode
has 31
c
hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 032, No. 3 projector’s address 063, No. 4
projector’s address94, and so on.
Launch the projector. Press key OK
more than 3seconds to unlock the display. After the unlocking, push key
► to enter into menus.
After selecting the sign of DMX setting, push OK key or tap the screen directly and select DMX address at 2
nd
level menus.
Push key
▲ or▼ or tap sign < or > to set the number desired.
Push
OK key
to confirm.
Push key
◄ and
it will return to the upper menu
.
●
DMX WIRELESS CONTROL
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1.
Enter into the projector’s menu. Select the menu “Config Settigns” via the keys of
▲
and
▼
2.
Select
DMX control Mode
----
Wireless First
(Note: Do not select
XLR ONLY).
The DMX wireless control
function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it, Press
“Enter” for the menu of Unlink Wireless under the upper level menu of Config Settigns.
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
Содержание PR-8170A
Страница 25: ...25 ...
