9/20
●
DMX WIRELESS CONTROL
(If the projector has the function)
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1.
Enter into the projector’s menu. Select the menu “Config Settigns” via the bottoms of
UP and DOWN
2.
Select
DMX control Mode
----
Wireless First
(Note: do not select
XLR ONLY),
then wireless indication in the
front panel will be on, meaning wireless control function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it,
Press “Enter” for the menu of Unlink Wireless under the upper level menu of Config Settigns .
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512
.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
●
AUDIO CONTROL
Select audio control under operation mode and set audio sensitivity(0-100) in the parameter settings based on different application
environment.
Note: If multiple projectors are connected in series, only master’s sound control works.
DMX OUT
MASTER
SLAVE
SLAVE
DMX IN
DMX OUT
DMX IN
DMX IN
TERMINATOR
