8
panel will be on, meaning wireless control function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it, Press
“Enter” for the menu of Unlink Wireless under the upper level menu of Config Settigns .
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the last
fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can be
set accordingly.
After Powered on, the group will run in Master/Slave Mode
6. OPERATION MENU
1
st
level menu
2
nd
level menu
3
rd
level menu
4
th
level menu
ADDR
(DMX address )
1-484
Rese
(Reset)
YES
CONF
DMX
DMX Mode
（
Default
：
Standard mode
）
Std 29
(Standard mode )
Ext 38
(Extended mode )
Shor 26
(Short mode )
LOSS
(Loss of DMX signal)
（
Default
：
Out
）
Out
(Device shut off)
Hold
(Hold last status)
SIGS
(Wireless Mode)
（
Default
：
XLR First
）
XLRF
(XLR first)
XLRO
(Only XLR)
Wi O
(Only wireless)
WI F
(Wireless First)
