6
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Before power connection, please ensure the power supplied must match what the nameplate says. It is recommended that each
projector be connected with power separately so that they may be individually switched on and off.
Note:
If projectors are connected in series, please connect POWERIN port of the 1
st
projector with the Power Mains, then connect its
POWER OUT with POWER IN of the 2
nd
projector, and so on till all fixtures are connected. If the voltage supplied is 200V-240V,
the maximum projectors connected is 8pcs, if it is 100V-120V, the maximum is 4pcs. The diameter of the cores of the wires for the
Power in/out cables must be equal or bigger than
2.5mm
2 .
●
The earth wire(yellow/green) must be connected to the ground. And electrical connection
must be in accordance with the standards concerned.
●
If any questions about the electrical installation, do not continue but consult a qualified
electrician.
●
DMX CONTROL CONNECTION:
Connection between controller and projector and between one projector and another must be made with a twin-screened cable, with each
wire having at least a 0.5mm in diameter. Connection to and from the projector is via cannon 5 pin (which are included with the projector)
or 5 pin XLR plugs and sockets. The XLR's are connected as shown in the figure above.
Note: care should be taken to ensure that none of the pins touch the metallic body of the plug or each other. XLR plugs and sockets mustn’t
be connected in any way other than mentioned in the above figure. The XR330BWS accepts digital control signals in protocol DMX512
(1990).
Connect the controller’s DMX output to the first fixture’s DMX input, and connect the first fixture’s DMX output to the second fixture’s
DMX input and connect the rest fixtures in the same way. Eventually connect the last fixture’s DMX output to a DMX terminator as shown
in the figure below.
●
DMX TERMINATOR
In the Controller mode, at the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This prevents electrical
noise from disturbing and corrupting the DMX control signals.
The DMX terminator is simply an XLR connector with a 120
(ohm) resistor connected across pins 2 and 3, which is then plugged into
4
N/C
N/C
5
PIN
FUNCTION
GND
1
3
DATA+
DATA-
2
DMX 512
DMX 512
2
DATA-
DATA+
3
1
GND
FUNCTION
PIN
五芯
三芯
DMX OUT
DMX IN
DMX IN
DMX OUT
1
2
3
1
2
3
4
5
1
2
3
5
4
3
2
1
