Ceiling Mount with a 7 Axis Extendable Arm and a 75-100mm VESA Screen Pan and Tilt Head
PN 80104-MICROS, PN 80104-20-MICROS, PN 80104-26-MICROS
10
WWW.PRACTICALQUALITYSYSTEMS.COM
(818) 993-1022
ALL PRODUCTS PATENT PENDING
Locating a Screen or Printer mount and examining the range of Motion of the arm(s).
1.1 Cut a section of blue painter’s tape that is the same width as the mounting plate and keep this handy.
1.2 Carefully Lift the mounting system, and place the mounting plate in contact with the mounting surface at
the proposed mounting location; then consider if the location of the MICROS pan and tilt head or printer tray
are accessible; but also not creating any conflicts with other items in the work area. If the system has movable
arm(s) move these through their entire range of motion and look for conflicts. If conflicts are found; adjust the
proposed location of the mounting plate as needed. When the optimum location is discoved; apply the tape to
the spot on the mounting surface.
1.3 An alternate method that can be used as an aid in determining the best location for screens or printers is to
make a cardboard cut out that has been shaped to closely match the overall dimensions of the intended screen
or printer tray. (In a pinch you can also use a tray or a pizza box as a stand in for a screen.) Use these
cardboard models as stand in for the actual equipment to assist in demonstrating the best positions of screens
or printers.
3.4 If the screen or printer is supported by an arm; locate the pivot points of the arm and then carefully guide
the MICROS pan and tilt head or printer tray horizontally through the entire range of movement to determine
optimum location for the mounting plate. When this location is discovered; apply the tape to the spot on the
mounting surface.
PN 80104-MICROS