page no. 12 of 16
PQ-A
Range Users, Installation & Servicing Instructions Doc Ref M308 issue 1.1 May 2019.
Note:
It is very important that the
replacement lamp is exactly the same as the
one the heater was supplied with.
Failure to fit the exact same type could cause the heater
to fail or even become dangerous especially when used in
an outdoor environment.
Please contact Powrmatic Limited to purchase your
replacement lamp and state the model
number of the heater you wish
to fit the lamp to.
Note:
Your new lamp(s) should
NOT
be handled
with bare hands. Remove finger marks with a
soft cloth and methylated spirits or rubbing
alcohol. Finger marks will burn into the lamps
quartz glass causing premature failure.
2.2.1. REPLACING A LAMP
Warning:
Unplug/switch off from the
mains power to the heater power before any
attempts are made to replace the lamp.
Contact your service agent for the correct replacement
lamp quoting model type and rating from rating label.
It is important that you read through the lamp
replacement procedure before commencing.
1. Disconnect the power supply to the heater.
2. Remove guard (where fitted) by flexing one end and
releasing from it’s locating holes on the lamp to be
replaced.
3. Remove either the three screws from
both front side covers on smaller
models, or remove the screws from
both sides the middle cover(s) on
longer models by as shown below.
4. Locate the lamp wire by the terminal and release from
tab. Repeat at other end.
