The eurotrol 2 comes preprogrammed with a typical heating program.
After installation the minimum setup required will be to program the current time and
date.
Power up
On initial power up a blank display followed by a partial
display will appear for up to 15 seconds before the full
display.
Programming the date and time if not correctly displayed
From the main screen
press
to enter the
password screen
Note: GMT and BST will automatically be set and will change automatically twice each year.
e
From the password
screen press
to enter the main
menu
e
Note: the factory set password is
From the main menu
screen press
5 times to enter the set
clock screen
From the set clock
screen press
to enter the setting
screen
e
Press
to adjust the hour
or
Press
to adjust the hour
or
Press
to move to minutes
Press
or
to adjust the minutes
Set date . month . year in a similar way. Note: day will be automatically set
Press
to enter the data and return to
the set clock screen
e
From the main menu
screen press
Press
or
to move to another
screen
Overview
Optimum stop:
Set temperature differential (preprogrammed to 0ºC).
Optimum stop will switch off the heating to save energy before the end of the
program time.
Example:
If the heating program calls for the building to be heated to 20ºC, but it is felt
that at the end of the heating program this temperature could drop to 18ºC with no detrimental
effect, then the optimum stop should be set to 2ºC (20ºC - 18ºC). This 2ºC will be applied
to any of the programs in use.
Note:
A setting of
0ºC effectively turns optimum stop off.
Heater fan runs constantly during program times in
heating mode.
Sets the temperature differential for hi / low operation.
Note: Hi / low only available with add on module.
Sets the temperature differential for optimum stop to begin.
Displays burner hours run and approximate running cost.
Note: Run log may also be displayed from the main display py pressing and
holding for 10 secs. (Password not required)
Enters data to calculate approximate running cost.
Displays service reminder and contact phone No.
Menu only available to Powrmatic service engineers.
Constant Run Fan
Optimum Stop
High / Low Differential
Run Log
Power and Cost
Service Date
Engineer Menu
8
13
Alternatively press or wait 30secs to return to main screen
Override
e
Содержание Eurotrol 2
Страница 2: ...2 19 Notes ...
