12-16-13 Revision
1-STAGE SNOW THROWER
8
GB
Following the assembly directions below,
you will assemble the snow thrower in a few
minutes
Handle
Install the handle to the lower handle using
four M10X45 screws, washers and nuts. Be
sure not to pinch or kink the auger clutch
cable in the process.
Slowly pull the recoil starter handle up
towards the eye bolt.
Place the chute crank lever onto the chute
rotation rod and secure with the screw and
nut.
Align the holes in the chute base with the
holes in the lower chute and secure with
three screws.
Slip the recoil starter rope into the eye bolt
from the back of the snow thrower.
2.
3.
1
1
2.
ASSEMBLY
Discharge Chute
M10 X 45
X 4
A
M5 X 25
X 1
B
ST6.3 X 25
X 3
C
Do not overtighten the screws;
otherwise you may damage the
discharge chute and prevent it from
turning freely.