8
Pow’R’kraft Snow Blower PK30230L
8
Revision 9-28-16
Following the assembly directions below,
you will assemble the snow thrower in a few
minutes
Slide the wheel bushing, the wheel and the
washer onto the axle.
Install the snap ring to secure the wheel assembly.
Push the wheel cover into the wheel hole.
Repeat with the other wheel assembly.
Install the handle to the lower handle using
four M10X50 screws, washers and nuts. Be
sure not to pinch or kink the auger clutch
cable in the process.
Slowly pull the recoil starter handle up
towards the eye bolt.
Slip the recoil starter rope into the eye bolt
from the back of the snow thrower.
Align the holes in the chute base with the holes
in the lower chute and secure with the self-
tapping screws.
1.
2.
3.
4.
1
2.
3.
ASSEMBLY
Discharge Chute
Wheels
Handle
X 2
B
ST6.3 X 25
X 4
A
M10 X 45
X 4
C
Do not overtighten the screws;
otherwise you may damage the
discharge chute and prevent it from
turning freely.
