15
Pow’R’kraft Snow Blower PK30230L
15
Revision 9-28-16
MAINTENANCE
Engine
Lubrication
Refer to the Engine Operator’s Manual.
Lubricate the pivot points on the auger clutch
lever and the spring at the end of the clutch
cable with a light oil once every season before
off-season storage.
At the end of the season or if the snow
thrower will not be used for 30 days or longer,
follow the storage instructions below.
Refer to the Engine Manual for
information on storing your engine.
Off-Season Storage
Run the engine until the fuel lines and
carburetor are empty and it stops due to
lack of fuel.
Remove the safety ignition key and allow
the engine to cool.
Lubricate the machine as instructed.
Clean the exterior of the engine and the
snow thrower thoroughly.
Touch up all rusted or chipped paint
surfaces; sand affected areas before
painting, and use a rust preventative to
prevent the metal parts from rusting.
T i g h t e n a l l l o o s e s c r e w s , b o l t s , a n d
locknuts. Repair or replace any damaged
parts.
Cover the machine and store it in a clean,
dry place out of the reach of children.
1.
2.
3.
4.
5.
6.
7.
Remove the screws that hold the belt
cover in place and set the cover aside.
Route the new belt around the drive pulley
and under the idler pulley.
Remove the auger pulley and the belt.
1
3.
2.
SERVICE
Auger Belt Replacement
If the auger belt becomes worn, oil-soaked,
or otherwise damaged, proceed as follows to
replace the belt.
