AFTER USING THE MACHINE
• Upon completion, dust mop with treated mop to pick up all burnishing
residue.
• The condition of the floor pad has direct affect on the performance of your bur-
nisher. When the pad becomes dirty, turn it over and use the other side. When
finished, wash the pad out and allow it to dry completely before using again.
• Unplug the power cord and wrap it under the cord hook and over the right
handle grip.
• Tip the machine back and remove floor pad.
• Wipe off the machine housing and the cord. This will prevent build-up of
unnecessary residue.
TRANSPORTING THE P1200, P1600
AND P2000
Use the rear wheels for transporting the P1200, P1600 or P2000. This will
insure that the operating wheels remain clean and smooth for use on clean floor
surfaces.
See picture # 4 (below left).
MAINTENANCE FOR THE P1200,
P1600 AND P2000
• Once a month, remove the motor cover of the unplugged P1200, P1600 or
P2000 by pulling evenly, but firmly, with both hands until cover is removed.
• Vacuum out any dust or debris which has accumulated in the motor.
See picture # 5 (below).
• Replace motor cover by setting it over holes in housing and firmly pushing
down.
• Check and maintain tightness of all fasteners.
WARNING:
do not over-tighten switch housing screws.
• Keep the burnisher clean, especially at the handle tube and collar so the
handle tube will move freely through the collar.
• Inspect cord and plug for cuts, gashes or loose prongs; replace as needed.
• The length of the carbon brushes should be inspected annually. If they are no
longer extended past the holder window, they should be replaced.
• Replacement of carbon brushes should be done only by a qualified service
technician.
•
Disassembly of this motor voids the warranty.
• Improper disassembly and assembly of this motor can permanently damage
the armature.
Picture #1
Picture #2
Picture #4
Picture #3
Picture #5
