7
Recharging the batteries:
The operation must be done in an appropriate room with sufficient air
recycling. Use the cable supplied to connect to the mains supply, normally 120 V 60 Hz; make
sure that the supply voltage is the same as indicated on the battery charger itself. The charger
will begin to charge the batteries.
Solution Valve:
Use lever M4 (page 8) to regulate the dosage of detergent according to the
amount of dirt and the speed of the machine, this will come with experience; at this point the
floor cleaner will simultaneously clean and dry the floor:
Splash Guard:
To replace the splash guard:
Release the latch on the right side of the brush housing. Remove the screw at the opposite end
of the retainer strip. Remove the retainer strip from the splash guard. Install the retainer strip in
the same groove in the new splash guard. Reverse the procedure to install the splash guard.
Batteries
: Check the electrolyte level and top up with distilled water if drops below the level of
the battery elements. Keep the batteries clean and dry with anti-static cloths. Recharging must
be carried out with the cell plugs removed and the cover of the machine opened so as to allow
the gases generated to escape. In confined spaces these gases can be explosive, so recharging
should be done in a well ventilated area.
Brush:
The brush must be kept in working order; to remove a worn brush proceed as follows
Turn off the machine (key switch in 0 position) and lift the brush with the pedal M7 (page 8);
Unhook the brush by rotating it manually and dropping it onto the floor.
Replace the brush with the new one leaving it one the floor under the unit.
Turn on the machine again as described in the previous paragraph, put the speed potentiometer
in the zero position. Operate the lever M8 (page 10) to turn ON the brush motor.
Release the pedal M7 (page 8). If the brush isn’t hooked up immediately you have to make small
side movements with the unit until the brush is hooked up.
WARNING: the use of brushes and non original spare parts can be dangerous. IN ANY CASE
FOR YOUR SAFETY AFTER THE ROTATION OF THE BRUSH BE CAREFUL NOT TO COME IN
TOUCH WITH MOVING PARTS OR ROTATION.
The machine is supplied with a pad driver and a red pad.
The brushes pressure can be adjusted using the lever M40 (page 8). From 50 to 70Kg max;
