6
For lifting and transporting use only specialized personnel (slingers, crane operators, etc.) with proper
lifting gear which is suitable for the weight of the various components.
Transport (especially by road) must be carried out in the correct way and with the adequate means so
as to protect the components (especially the electronic ones) from violent shocks, humidity, vibration,
etc.; the machines are supplied with wheels and therefore need to be securely anchored before
beginning transportation.
We remind you that packing material (wood, nails, paper, cellophane, metal staples, adhesive
tape, straps, ropes, etc.) may cause cuts or wounds and should be handled with care. These must
be removed with appropriate tools and should not be left in the care of irresponsible people (e.g.
Children); the same applies to the unpacking tools (scissors, hammers, pliers, knives, etc.).
On specific request, the Manufacturer will pack the machines appropriately but this does not eliminate
the above safety notes.
During movement, suspended loads made up of machine components or parts represent a collision,
risk, it is the responsibility of the customer to highlight this danger.
Detergent tank
: The detergent tank is positioned underneath the recover tank with the water filling
cap M1 (page 7) easily accessible for easy refilling. Before filling the tank with correctly diluted
detergent, empty the waste collection tank as described in the following paragraph; obviously this
step is not required for the first time of filling. The capacity of the detergent tank is 16 gallons. Only
use the quantities and dilution recommended by the detergent supplier and use only non foaming
detergents.
Waste tank:
The waste tank should be emptied (preferably after each use) so as not to let the dirt
settle; to do this, remove the cap covering the drain tube M2 (page 7) which is held in place by a
retaining spring, and put in a position so that it drains. Or empty the tank and clean it with the help
of the cap M0 (page 7). Always abide by the environmental regulations of the country where the
machine is used.
Squeegee Assembly:
The squeegee assembly serves to finish the drying operation and it is very
important to ensure it is in the correct position: lower the squeegee to its working position by releasing
the lever M3 (page 7).
Recharging the batteries:
The operation must be done in an appropriate room with sufficient air
recycling. Use the cable supplied to connect to the mains supply, normally 120 V 60 Hz; make sure
that the supply voltage is the same as indicated on the battery charger itself. The charger will begin to
charge the batteries.
Do not leave any metallic tools or objects of any kind on the machine (see also IMPORTANT
SAFETY INSTRUCTIONS) (page 3).
The area to be cleaned:
The area to be cleaned should first be swept (manually or by machine) to
remove loose dirt which may quickly clog up the vacuum system circuit.
Solution Valve:
Use lever M4 (page 7) to regulate the dosage of detergent according to the amount
of dirt and the speed of the machine, this will come with experience; at this point the floor cleaner will
simultaneously clean and dry the floor:
Splash Guard:
To replace the splash guard:
PFS20
, remove the (5) screws holding the retainer strip onto the brush housing. Install new splash
guard and reverse the procedure.
PFS24
- Release the latch on the right side of the brush housing. Remove the screw at the opposite
end of the retainer strip. Remove the retainer strip from the splash guard. Install the retainer strip in
the same groove in the new splash guard. Reverse the procedure to install the splash guard.
