6
The area to be scrubbed:
Debris and grit must be swept up before starting the scrubbing operation
to avoid vacuum line blockage and to permit the detergent to perform efficiently.
DO NOT OPERATE ON RAMPS OR INCLINES unless adequate personnel are available for
assistance.
Starting up and operation:
Plug the machine into an outlet position allowing operation by moving
away from the outlet.
NOTE:
The PAS20E is intended for use with 120V/60Hz cycle grounded circuit. Extension cords are
not recommended.
Then:
• Press switches
M7
and
M8.
• Lower the brush by pressing pedal
M9.
• Lower the
squeegee by depressing pedal
M3.
• Set the detergent solution supply to minimum by adjusting
knob
M12.
Experience will help with the selection of the correct solution amount. Moving outward
away from the outlet will allow the cord to be kept off of a dirty floor and also from dragging dirt
into the cleaned path. • Depress the handle (M10) to begin scrubbing with the brush. Release the
handle (M10) to stop the brush from turning.
Particularly dirty floors:
Certain floors or areas may require special attention and, in some cases,
cleaning twice. Go over the floor quickly the first time, with the squeegee raised and the brush in
the working position. In this way, the detergent solution is left on the floor for a longer time and can
dissolve the heavy dirt. The second time, go over the floor more slowly with both the brush and the
squeegee lowered.
STOP
START
NO
M9
M6
M7
M8
M3
M10
M12
