5
Solution Tank:
The solution tank is located under the lid, at the front of the machine, with the
filling-funnel M1 in an accessible position for easy re-filling.
WARNING
: Always switch off and unplug the machine before filling the solution tank.
Note: Always empty the dirty water collection tank, as described in the next paragraph, before
refilling the tank with the diluted detergent solution. The solution tank has a maximum capacity of
17 gallons (30 liters). Always use the products and the dilution quantities recommended by the
seller. Always use low foam detergents. Use defoamer if excess foam develops. Remove hose
from vacuum intake and pick up defoamer directly into the recovery tank.
Water collection tank:
The dirty water collection tank should be emptied, preferably each time
after use, so that the dirt does not settle there. To do this, remove the plug of the drain hose
M2, which is kept in position by a simple spring clip, and empty dirty water into the proper drain
conforming to local regulations.
Squeegee
: The squeegee has the final task of completing the drying of the floor and it is very
important for it to be in the correct position. Lower the squeegee to the working position by
depressing pedal M3 as shown. Adjust the position of the squeegee by means of the knobs
M4 so that the black rubber bar is about 1⁄32” (the thickness of a business card) from the floor.
The squeegee behind this is in para rubber and must press on the floor with a certain amount
of force. After the first few hours the squeegee adjusts itself to the correct angle and drying
becomes even better. Squeegee pressure is adjusted by knob M14.
M3
M2
M4
M14
M1
1m
m
