5
Warning!
This machine is heavy. Do not attempt to lift the machine without assistance. Incorrect lifting tech-
niques may result in personal injury.
PREPARING FOR USE
(4)
(1)
(2)
(3)
(5)
(1) Bottom handle
(2) Machine body
(3) Component housing
(4) Solution tank
(5) Top handle and solution cable
(6) Handle LH & RH
(7) Brush shafts (2)
(8) Screws & washers
(9) Cable retainer
(10) Power cord
(11) Dirty water tank
(12) Handle knobs
(6)
(7)
(8)
(9)
(10)
(11)
(12)
1. The Powr-Flite Multiwash 14 ships with the handle dismantled. To assemble, verify that all of the parts listed are included.
2. Remove the hook, which holds the bottom handle with the machine body, while holding the bottom handle.
Warning!
Since the bottom handle is spring loaded, care must be taken when removing the hook to avoid
sudden springing back, leading to possible injury to personnel.
UNPACK
ASSEMBLY
1. Insert the two tubular handles into the bottom handle and secure them using handle knobs
(12) by tightening lightly. Verify that the handles are assembled according to their marked
position and the cable holding hooks are pointing towards the rear.
2. Slide the electric cable retainer into the top portion of RH handle.
3. Fit the top handle over the tubular handles and secure them with a washer and screw (2
sets). Ensure that the label on the top handle is facing the front of the machine. Now firmly
tighten both the knobs and screws alternately. Insert the dummy caps provided to cover the
screws (2) in the top handle.
4. Pass the free end of the pull cable through the plastic guide in RH Handle. Press and twist
clockwise to firmly secure the cable end to the fitting in the component housing.
5. Fix the auxiliary tank firmly into the bottom handle by holding the top handle.
6. Rotate the knob to hold the auxiliary tank.
7. The brushes are only loosely packed in the machine for transit. The brush shafts must be
fitted before operating the machine. Push the shafts through the brushes from the side of
the machine. To remove brushes, push the brush shaft out from the side of the machine and
remove the shaft. Normally the standard brush will be supplied with the machine. Brushes
should be selected according to the type of floor surface to be cleaned and the type of dirt
to be removed. Please refer Brush Selection Guide.
8. The machine is now ready for use.
RIGHT
BOTTOM
REAR
LEFT
BOTTOM
REAR
https://harrissupplyind.com - To Order Parts Call 608-268-8080
