DYNAMIC 1500 FPV
- 2 -
Dear customer,
Congratulations on your choice of a factory-assembled model aircraft from the POWERZONE and
thank you for placing your trust in us.
Very little preparation work is required to get this model ready to fly. To operate your new model
safely it is important to that you read through all of the instructions and safety information included with
your model, before you fly it for the first time.
The illustrations in this manual show the Grey version of the model with factory applied decals.
The power system
The model is powered by a brushless outrunner motor and ducted fan, both of which are
factory-installed on the Ready-To-Fly version.
The motor is connected to the electronic speed controller which is factory calibrated on the
Ready-To-Fly version. All that is required is to charge the Li-Po battery, following the safety instructions,
and connect the battery to the electronic speed controller.
The radio control system
To fly the DYNAMIC 1500 FPV you will need a radio control system with at least four channels. 2.4GHz
radios systems are recommended, similar to the unit included with our deluxe version.
The servos for the ailerons and the elevators are factory-installed.
The power for the receiver is drawn from the electronic speed controller’s integral BEC system.
The electronic speed controller is located inside of the fuselage, in front of the ducted fan.
To check the model’s operating systems, first set the control surface servos to neutral and with the
transmitter sticks and trims at centre.
When you wish to fly the model, always make sure the transmitter is in the “OFF” position. Move the
throttle stick to the “OFF” position as well. Then connect the flight battery to the electronic speed
controller.
Switch off in the reverse order: disconnect the battery from the electronic speed controller first, and then
switch off the transmitter.
Glued joints, suitable adhesives
