D0136 RevC
5
C19-01-01
1. Inspect hose and connections daily. Replace damaged components immediately with PowerX
Authorized replacement parts only.
2. Tighten connections as needed. Use pipe thread Teflon when servicing connections. NOTE:
DO NOT OVER TIGHTEN CONNECTIONS.
3. When not in use or during storage:
• Disconnect pump from air source, depressurize and disconnect hydraul
ic hoses from
application.
• Wipe clean, throughout.
• Shelter the pump with protective cover.
• Store in clean, dry environment.
• Avoid temperature extremes.
B) HOW TO FILL THE RESERVOIR
1. Disconnect hydraulic hose from application, remove air source from pump.
2. With reservoir horizontal, remove the vent / oil filler plug.
3. Use a small funnel to fill reservoir so the oil level remains the distance stated below in the
table, distances are measures from the top of the fill hole.
Model
Recommended Oil Level from the Top of Fill Hole
Minimum Fill Lever
Maximum Fill Level
PA6-98C, PA6-122, PA6-98R, PA6-122D
1.25"
.5"
PA6-231, PA6-231D, PA6-460D
2.25"
1.5"
4. Use PowerX oil only (Model PL-1, 1 gallon). Using oil other than PowerX Brand may void the
pump warranty.
5. Wipe up any spilled fluid and install oil filler screw.
6. Return pump to original position (parallel to a flat level surface), reconnect application and air
source. Operate for a few seconds, and then check for leaks.
C) CHANGING THE OIL
1. For best results, change fluid once a year.
2. Repeat steps (B) “How to Fill Reservoir”, and then pour used fluid into a sealable container.
3. Fill with PowerX oil. Reinstall oil filler plug.
D) LUBRICATION (When no in-line oiler is used)
1. When used daily, pour a teaspoon of good quality air tool oil #10 non-detergent oil into the
air source inlet of pump. Connect hydraulic hose to application, connect air source to pump and
operate pump a few seconds to evenly distribute fluid.
