044-05236 Rev A
3-1
Chapter 3
Installation
3.1
Introduction
This chapter contains unpacking, inspection, startup and installation procedures for the G3L-850-160
Multi-Carrier Power Amplifier (MCPA).
•
Review this chapter prior to equipment installation.
•
Review any government and local codes applicable to this installation.
•
Read the instructions in this Chapter and Chapter 4 before operating the equipment.
3.2
Unpacking and Inspection
Perform the steps in Table 3-1 to unpack and inspect the MCPA.
3.2.1 Damaged Equipment
If the MCPA is damaged, a claim should be filed with the carrier when the extent of any damage is
assessed. Contact the factory for a return material authorization (RMA). Refer to Chapter 4 for the
return procedure.
3.3
Air Conditioning Requirements
The MCPA generates 2770 BTUs of heat at 36 amps, 27 VDC and 160 watts average RF power
output. The MCPA operates within the extended low temperature and high temperature environments
as listed in Chapter 5.
3.4
MCPA Installation Instructions
Table 3-1 MCPA Unpacking and Inspection Instructions
Step
Action
1
Carefully open container and remove MCPA.
2
Visually inspect MCPA for damage that may have occurred during shipment.
Check for evidence of water damage, bent or warped chassis, loose screws or
nuts, or extraneous packing material in connectors. If possible, inspect equipment
in the presence of the delivery person.
3
If possible, retain all packing material that can be reused for repackaging
components.
CAUTION: Do not slam the MCPA into the system subrack during installation. Using
excessive force can damage the MCPA interface connector.
