SOP – How to assemble Battery Pack with 6 batteries (BP A36T-6x9Ah)
3. Put the three batteries in order as
shown in chart.
Hint: Install the left
one and keep battery terminal
heading the bottom. Then, install the
middle one and keep battery terminal
heading upwards. At least, install the
right one and keep battery terminal
heading upwards.
4
．
Put grommet inside the hole of
battery divider and allow red and black
wire passing through the hole. Screw
tightly the battery divider with screw
nuts. (as shown in 1, 2 areas)
M4 screw nuts: 38-210003-00G*2
Torque: 8KGF-CM
1.As shown, please use three batteries (12V/7Ah or
12V/9Ah
）
and check the date code (it’s necessary
to use batteries with same date code in a UPS unit).
Serial connect batteries with three black wires in
450, 280, 150 mm length. Slip the end of black wire
with 280mm length into the tube.
2. Connect red wire with 380mm length to battery
and slip red wire into the tube.
NOTE: This will prevent short circuit from direct
contact of terminal.
2
3
1
CAUTION:
1. Be sure all wires are plugged correctly and tightly. Do NOT break any
wire tubes. 2.Do NOT connect battery terminal to any metals. Otherwise, it will
cause short circuit. 3.
Any screw should be screwed tightly without missing.
Tool: electric screwdriver, crosshead
screwdriver, nipper
380mm
450mm
280mm
150mm
1
2
4
3
Tubes
1
2
Red wire passes
here
Black wire passes
here
Содержание BP A36T-6x9Ah
Страница 1: ...User Manual Battery Pack ...
