8
5) Remove the terminal block cover on the rear panel of Charger.
Then connect the wires according to the following terminal block
diagram: (Always connect the earth wire first!)
Wiring connection on the Charger rear panel
Warning:
!
Make sure a DC breaker or other protection device between the
Charger and battery banks is installed. If not, please install it carefully.
Switch off the battery breaker before installation.
!
Pay high attention to the rating battery voltage and it should be
240VDC, the connection with wrong battery voltage may cause
permanent damage of the Charger. Make sure the voltage of the
battery banks is correct.
!
Pay high attention to the rating battery capacity and it should be
bigger than 65AH, Wrong connection may cause permanent
damage of the battery
!
Pay high attention to the polarity mark on battery banks terminal
block, and make sure the correct battery polarity is connected.
Wrong connection may cause permanent damage of the Charger.
!
Make sure the battery input wiring is correct before power on. The
wire current spec, color, position, connection and conductance
reliability should be checked carefully. Make sure the +/- polarity is
correct, not reverse, no short circuit.
