11
3.2 Mounting the Modules
Step 1:
Clip two SNAP bushings into the stand feet. Then, fix two fixing
plates on the stand feed (both sides) with
eight screws. finally, fix two L-
type brackets on the battery module (both sides) with four screws.
Step 2:
Install one battery module by following below steps.
(a)
Use a Ø13mm drill to drill holes about 60mm deep according to the
distance indicated on the below chart. Drill two holes on the floor first,
then drill two holes on the wall. If there is one more battery module to
be stacked up, drill two holes at a vertical distance of 420mm.
583
.
00
mm
85
.
00
mm
85
.
00
mm
612
.
5
mm
612
.
5
mm
420
.
00
mm
410
.
00
mm
Floor
Wall
