Handlebar Adjustment
To adjust the handlebar height, simply turn the adjustable knob loose, then adjust the bar to the
required height and retighten the knob.
Chain Adjustment
•
The chain on the bike has been pre-adjusted and should not require immediate attention.
•
Continuous use of the bike may cause the chain to stretch or become loose, needing adjustment.
•
To adjust the chain, loosen the nuts on both sides of the main axle, then tighten the bolts and nuts
on the two sides of the axle.
EXERCISE COMPUTER
CAUTION:
Computer readouts are to be used as a rough guide for exercise and is not to be regarded
as medically accurate.
Button Functions:
•
Mode:
Press to selection function and hold for 4 seconds to reset.
•
Scan:
Automatically scan through each function
•
Time:
Total cycling time up to 99.59
•
Speed:
Total speed up to 999.9km/h or ML/H. Value will stay constantly on the monitor
•
Distance:
Total cycling distance up to 99.9km or mi from 0.
•
Calorie:
Calorie consumption of maximum value of 999.9 calories
•
Pulse
(if applicable): Displays the heart rate during exercise. Put the ear clip on your left earlobe
before monitoring pulse. To obtain a more accurate pulse, rub your earlobe 15 times prior to
clipping on.
Note:
•
Once exercise has stopped, there will be a stop sign displayed in the upper-left corner.
•
Display unit will shut off with inactivity longer than 4 minutes.
•
Monitor can be turned on by pressing the button or pedalling
•
If the monitor is not displaying correct information re-install the batteries to correct.
•
Battery specifications: 1.5V UM-3 or AA (2pcs)
Troubleshooting
•
Changing the computer battery - slide the computer from the computer holder, remove the battery
cover on the back of the console and remove the batteries. Replace with 2xAA batteries. Replace
the cover on the console, and slide the computer back on to the computer holder.
•
Computer not working correctly - If your computer is not working correctly, please check
whether the lower sensor wire is connected to the upper sensor wire, and make sure the upper
sensor wire is plugged into the computer. When you have checked the above, and the computer
still not working, then please make sure the batteries are installed correctly in the computer and
the batteries are still working.
•
No resistance - If there is no tension resistance on the bike, please make sure the upper tension
cable is connected to the lower tension cable. Turn the tension knob anti-clockwise to its lowest
level, then go to the tension strap-buckle which is situated on top of the flywheel cover at the base
of the front post. Loosen the tension strap, pull it through the buckle until you can feel some
Содержание LZ100
Страница 3: ...FEATURES ...
