Charging Options
1. Connect device to car charger through USB port, the device will power on automatically, enter standby
mode and start charging with green indicator light on.
Once the device is fully charged, the green indicator light will go out.
2. Connect device to PC via USB cable, device will power on automatically. Turn device off to begin
charging, the status light will turn green. Once the device has been fully charged the green indicator light
will turn off.
Power capacity
For the power capacity of the battery, refer to the following icons:
Full Middle Low
Installation and Removal of SD Card
1. Insert the SD Card in the direction indicated on back of device until it is held firmly in device.
2. To remove SD Card lightly press the SD Card and the card will eject out.
[Note]
1. Observe the direction to insert the SD Card. If inserted incorrectly the device and the SD Card may be
damaged.
2. When the SD Card is inserted into the device, the machine will set the SD card as a pre-set storage unit
and any data on the original SD card will be erased.
3. If device reports the SD card is incompatible with the device please eject and try again. If still
incompatible then please buy compatible card.
4. Max 32GB Supported. Must be high speed memory card such as class 10 or higher, slower SD cards may
not be compatible.
