18 INSTRUCTIONS PW220/PW230
3)
The gap between the bottom of electric latch and the
stopper should be less than 7mm. See
Figure 2.3.7 (10)
Figure 2.3.7(10)
For the gate opened
inward.
Figure 2.3.7(11)
for the gate opened
Outward.
4)
Connect the wires of the electric latch to the
terminal LATCH and GND on the PCB.
See
Figure 2.3.8 (5)
2.3.8 PC160 Control Box
1.
Decide the installation position of PC160 control box
first, it is suggested to be installed near the gate and
should be protected from possible damage. Be aware of
the motor cable length before deciding the installation
position.
2.
Remove the cover by unscrewing the four screws on the
cover. See
Figure 2.3.8 (1).
Figure 2.3.8 (1)
3.
Use a screwdriver to puncture the holes beneath the
bottom of the control box. See
Figure 2.3.8 (2).
Figure 2.3.8 (2)
4.
Secure it on the wall. See
Figure 2.3.8 (3).
Figure
2.3.8 (3)
Содержание PW220
Страница 1: ......
Страница 21: ...20 INSTRUCTIONS PW220 PW230 Figure 2 3 8 4 ...