PowerTec PL1252, Руководство пользователя

Страница: 5 / 20

INSTALL ELEVATION CRANK HANDLE
Refer to Figure 2 and 3
• The planer handle can be installed to the top-right of the
planer.
• Insert handle onto elevation screw top.
• Secure handle with bolt and flat washer using the
enclosed wrench.
• Insert plug into handle
Figure 2 - Install Handle
Do not use the machine until it is completely assembled
and you have read and understood the entire operating
manuals.
• The machine must be installed in a well-lit area with
correct power supply.
• There must be enough clearance for the moving
workpiece during operation. There must be enough
room for safe operation of the machine.
POWER SOURCE
Do not connect to the power source until the machine is
completely assembled.
The machine is wired for 120 Volts, 60 Hz alternating
current. Before connecting the machine to the power
source, make sure the switch is in the "OFF" position.
Running the unit on voltages which are not within range
may cause overheating and motor burn-out. Heavy loads
require that voltage at motor terminals be no less than the
voltage specified on nameplate.
• Power supply to the motor is controlled by a locking
rocker switch. Remove the key to prevent unauthorized
use.
GROUNDING INSTRUCTIONS
Improper connection of equipment grounding conductor
can result in the risk of electrical shock.
• The machine should be grounded while in use to protect
operator from electrical shock.
• In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an
escape wire for the electricity.
• This machine is equipped with an approved 3-conductor
cord rated at 120V and a 3-prong grounding type plug
(Figure 4) for your protection against shock hazards.
• Grounding plug should be plugged directly into a
properly installed and grounded 3-prong grounding-type
receptacle, as shown (Figure 4).
• The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
• Check with a qualified electrician or service personnel if
these instructions are not completely understood or if in
doubt as to whether the tool is properly grounded.
• Do not modify plug provided. If it will not fit in outlet,
have proper outlet installed by a qualified electrician.
Use only 3-wire extension cords, that have 3-prong
grounding type plugs and matching 3-conductor
receptacles that accept the machine's plug, as show in
Figure 4.
WARNING
Figure 3 - Secure Handle
WARNING
WARNING
Elevation Screw
Handle with Knob
Plug
Bolt
3
ASSEMBLY