Powersmart DB72024PA, Инструкция по эксплуатации

Страница: 18 / 38

18
OPERATING YOUR SNOW THROWER
MANUAL START THE ENGINE
To manual start the engine, perform the following steps:
1.
Check the oil and fuel levels.
2. Turn the fuel valve to the “ON” position.
3. Move the choke lever to the “CLOSE” position.
4. Make sure insert the switch key.
5. Press the primer bulb 3 times.
6. Pull on the recoil starter handle slowly until a slight resistance is felt, then pull quickly to start the
engine. Return cord gently into the recoil starter. Never allow the cord to snap back.
7. If engine fails to start, repeat step 6. NOTE: After repeated failed attempts to start the engine, please
consult the troubleshooting guide before attempting again. If problems persist, please call customer
service.
8. Once the engine has started, slowly return the choke lever all the way to the “OPEN” position.
9. Allow the engine to run for several minutes before cleaning snow. This allows the engine to stabilize
its speed and temperature.
ELECTRIC START THE ENGINE
To start the engine using the electric start function, perform the following steps:
1.
Check the oil and gas levels.
2. Turn the fuel valve to the “ON” position.
3. Move the choke lever to the “CLOSE” position.
4. Make sure insert the switch key.
5. Press the primer bulb 3 times.
6. Plug the power cord to starting motor.
7. Press the start button for 2-3 seconds or until the engine starts. NOTE: If the engine does not start
after 2-3 seconds, release the start button.
8. If engine fails to start, wait 10 seconds, then repeat step 7. NOTE: After repeated attempts to start the
engine, please consult the troubleshooting guide before attempting again. If problems persist please
call customer service.
9. Once the engine has started. Slowly move the choke lever all the way to the “OPEN” position. Allow
the engine to run for several minutes before attempting to clean snow.
CLEARING SNOW
Start the engine once your snow thrower has been running outside for several minutes, it is now ready for
use. Make sure the path in front of your Snow Thrower is free from people, animals, objects, and all other
obstructions except for snow.
Adjust the chute outlet to the desired direction.
Turn the chute rotation handle clockwise or counter-clockwise until the desired position is reached.
WARNING! Never direct the chute outlet toward people or animals. While snow may seem harmless, it
can contain rocks or other debris that can cause serious injury when projected through the chute.
1. Engage/depress the auger control lever (handle) to start the augers and impeller turning.
2. Set the desired direction and speed using the speed/gear control lever.