PowerShot PS3611ES, Инструкция по эксплуатации

Страница: 8 / 24

8.
FILLING THE FUEL TANK
CAUTION: Risk of fire. Handle fuel
carefully.
Do not add fuel when product is operating. Stop
engine and allow engine to cool for 5 minutes before
refueling. Hot surfaces can cause burns and ignite
spilled fuel. Do not touch muffler.
Fill fuel tank outdoors away from flames and open
sparks.
Do not smoke when filling fuel tank.
Do not overfill fuel tank. (There should be no fuel
in filler neck.)
Avoid spilling fuel. Wipe clean after refueling.
Move from refueling area before starting.
Prevent fires by keeping engine clean of
accumulation, grease, trash and debris.
3.
Inlet
Screen
2.
Connect high
pressure hose here
CONNECTING HOSE & WATER
SUPPLY TO PUMP
1. Uncoil high pressure hose and attach the end of
the hose to base of spray gun (Fig. 2).
Pull coupler locking ring back and push into male
hose fitting. Release coupler locking ring and
check connection.
2. Similarly, attach other end of high pressure hose
to high pressure outlet on pump.
3. Before connecting garden hose to water inlet,
inspect inlet screen (Fig. 3). Clean screen if it
contains debris, replace if damaged. DO NOT
RUN WATERBLASTER IF SCREEN IS
DAMAGED.
4. Run water through garden hose for 30 seconds
to clean out any debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for
the water supply. Use ONLY cold water (less than
40°C).
5. Connect garden hose (not to exceed 10 metres
in length) to water inlet (Fig. 3).
IMPORTANT: Do not permit
dirt or other foreign matter
to enter the fuel system.
This will cause hard
starting, poor performance
and engine damage. Always
use clean fuel storage
containers and funnels.
petrol. Do not use stale
petrol or petrol that has
been stored for a long
time. Stale petrol does not vaporise properly,
causing hard starts. Use of petrol stabilizer is highly
recommended . Use of leaded petrol or gasohol is
NOT recommended.
IMPORTANT: To avoid pump damage, you must
assemble the nozzle extension to the spray gun
and attach all hoses before you start the engine.
PS3611ES