PowerShot PS3611ES, Инструкция по эксплуатации

Страница: 13 / 24

13.
PRESSURE WASHER RINSING
After you have applied detergent, scour the surface
and rinse it clean as follows:
1. Apply safety latch to spray gun.
2. Remove black chemical spray tip from nozzle
extension.
3. Select and install desired high pressure spray tip
following instructions in ‘Selecting the Proper
Nozzle’.
4. Apply high pressure spray to small area and
check surface for damage. If no damage is found,
you can assume it is okay to continue cleaning.
5. Start at top of area to be rinsed, working down
with same overlapping strokes as you used for
cleaning.
C
1.
7.
7.
LEANING HORIZONTAL SURFACES
Move nozzle wand from side to side. Direct spray
at an angle to force debris ahead and away from the
cleared area (Fig. 6).
6.
2. Depending on the material to be removed and
nozzle pressure, hold nozzle end 20 to 25cm
from the surface and use slow overlapping ,
strokes.
3. If debris is easy to remove, move nozzle back to
cover more area for faster cleaning.
CLEANING VERTICAL SURFACES
IMPORTANT: Remember that the pressure washer
can deliver a high pressure spray that can break
glass and gouge soft wood and other materials.
When cleaning building interiors or exteriors without
detergents, work from top to bottom. This will help
eliminate streaks. In interiors, start with the ceiling
first, then the walls and the floor last.
CAUTION! Clean around windows
carefully.
and puttied, the high pressure spray could
break the glass.
CAUTION: Never spray directly overhead.
Always spray ahead to avoid dripping or
falling debris.
REMOVING PAINT
IMPORTANT: Remember that high pressure spray
can gouge soft woods and other materials, as well
as loosen grout.
1. Direct spray at a 45° angle about 10 to 30cm
from surface.
2. Spray in a back and forth motion, try to get
beneath the loose and bubbled paint.
3. Do not be concerned with the paint that remains.
It should be sufficiently bonded so as not to
cause repainting problems.
CAUTION! Never allow the pump to run
for more than a 2 minute period without
opening the gun. This will cause pump
damage due to excessive water temperature
and void the warranty. A thermal relief valve
has been added to the pump to reduce the
possibility of overheating, however,
malfunction of this device does not constitute
pump warranty for damage caused by
overheating.
PS3611ES