1. Introduction
Thank you for purchasing the VoltGuard PSVG1500, Automatic Voltage Regulator (AVR).
AVR-protected sockets will automatically maintain a constant voltage range to protect
sensitive electronics from brownouts and over voltages. The VoltGuard PSVG1500 can easily
be installed on a desk or wall mounting to minimize the foot print in limited work spaces.
Features:
Provides AVR-protected sockets
Provides stable output voltage through boost and buck stabilizer
Accepts wide input voltage range
Provides over-/under-voltage protection
Provides Over-temperature protection
2. Product Overview
Power switch
AC input
AVR-protected output receptacles
Over/under LED: red
Power LED: green
AVR LED: yellow
3. Installation and Initial Startup
Inspection
Remove the unit from the shipping package and inspect it for damage that may
have occurred during transportation. Notify the carrier and place of purchase if
any damage is found.
Placement & Storage Conditions
Install the unit in a protected area that is free of excessive dust and has adequate air flow.
Please place the unit away from other units at least 2.5cm to avoid interference. Do NOT block
the top or side air vents on the unit. Do not operate the unit in an environment where the
ambient temperature or humidity is outside the limits listed in the specifications. Operate the
unit in an environment free of excessive dust, mechanical vibration, inflammable gases and
explosive or corrosive atmospheres.
Connect to the Wall Outlet
Plug the input power cord of the unit to the wall outlet.
Connect the Loads
The AVR-protected receptacles will provide stable power to connected devices by boosting
and bucking the input voltage. Therefore, simply connect sensitive loads to AVR-protected
receptacles.
Turn On/Off the Unit
Turn on the unit by pressing the power switch to “RESET” position. Then, all connected
devices will be powered on.
VoltGuard PSVG1500
Quick Guide v.1.0
